Software

$	Beschreibung	Default	Wert	Anmerkung
0	Step puls, microseconds	10
1	Step idle delay, milliseconds	25
2	Step port invert, mask	0
3	Direction port invert, mask	0	1	X-Achse invertiert
4	Step enable invert, boolean	false
5	Limit pins invert, boolean	false
6	Probe pin invert, boolean	false
10	Status report, mask	1
11	Junction deviation, mm	0.01
12	Arc tolerence, mm	0.002
13	Report inches, boolean	false
20	Soft limits, boolean	false
21	Hard limits, boolean	false
22	Homing cycle, boolean	true
23	Homing dir invert, mask	0	1	X-Achse invertiert
24	Homing feed, mm/min	25.0
25	Homing seek, mm/min	500.0
26	Homing debounce, milliseconds	250
27	Homing pull-off, mm	1.0
30	Max spindle speed, RPM	1000.0
31	Min spindle speed, RPM	0.0
32	Laser mode, boolean	false
100	X steps/mm	250.0	400.0	(200×16)/8
101	Y steps/mm	250.0	400.0	(200×16)/8
102	Z steps/mm	250.0	400.0	(200×16)/8
110	X Max rate, mm/min	500.0
111	Y Max rate, mm/min	500.0
112	Z Max rate, mm/min	500.0
120	X Acceleration, mm/sec²	10.0
121	Y Acceleration, mm/sec²	10.0
122	Z Acceleration, mm/sec²	10.0
130	X Max travel, mm	200.0	160.0
131	Y Max travel, mm	200.0	100.0
132	Z Max travel, mm	200.0	60.0

GRBL